Cut Sheet

Volume 7—Logic Control, Operator Interface and Connectivity Solutions CA08100008E—June 2015 www.eaton.com V7-T1-233
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1.8
Pushbuttons and Indicating Lights
30.5 mm Heavy-Duty Watertight/Oiltight—10250T
Enclosures
Die Cast, Polyester and Stainless Steel Enclosures
Enclosures (Case and Cover)—Surface Mounting
1
Mounting Instructions
Two-position joystick must be
used with two contact block
deep enclosures (maximum
number of contact blocks = 1).
Four-position joysticks cannot
be used within these
enclosures.
One and Two Contact Block
Depth Enclosures Enclosure Layouts
Notes
1
For spacing increments, see Page V7-T1-234.
2
All die cast enclosures can be converted to base mounting of contact blocks, with spacers 10250TA22 or 10250TA23.
See listing on Page V7-T1-227.
3
When used with E30 pushbuttons, only the one element enclosure can be used.
4
When used with resistor light units, only the 2 contact block depth enclosure can be used.
5
14 gauge, type 304.
Number of
Elements
One Contact Block Depth
Catalog Number
Two Contact Block Depth
Catalog Number
Die Cast Enclosure—In-Line
234
NEMA 4, 4X, 12, 13
1 10250TN1 10250TN11
2 10250TN2 10250TN12
3 10250TN3 10250TN13
4 — 10250TN14
Polyester
4
—In-Line NEMA 3, 4X, 12
1 — E34N51
2 — E34N52
3 — E34N53
4 — E34N54
Stainless Steel
45
—In-Line NEMA 4, 4X, 12
1 — 10250TN33
2 — 10250TN34
3 — 10250TN35
4 — 10250TN36
Dimensions, see Page V7-T1-246.
Die Cast Enclosure
Polyester Enclosure
Stainless Steel
Enclosure
One Contact
Block Depth
Enclosure
Two Contact
Block Depth
Enclosure
111
Top – For Vertical Mounting
Top – For Horizontal
Mounting
1
222
33
4