Installation Guide

Catalog # 9590 ASPIRE™ 5-button Preset Minute Timer (Single Output) Catalog # 9591 ASPIRE™ 5-button Preset Hour Timer (Single Output)
Catalog # PT18M ACCELL 5-button Preset Minute Timer (Single Output) Catalog # PT18H ACCELL 5-button Preset Hour Timer (Single Output)
SPECIFICATIONS
• Single Pole
• No Neutral Required
•
15A (1800W) 120V AC 60 Hz
•
For Incandescent, Magnetic Low Voltage (MLV), Electronic Low Voltage (ELV), Fluorescent, Compact Fluorescent, LED,
M
otors up to 1/4 HP
•
Removable front face – allows use of color change kit
DESCRIPTION
• Replaces a standard Single Pole switch
• Preset times are 5, 10, 15, 30 and 60 minutes in the minute timer (Cat. Nos. 9590 and PT18M) and 1, 2, 4 , 8, and 12 hours in the
hour timer (Cat. Nos. 9591 and PT18H)
• Automatically turns off lights/fans after preset time
•
LED indicates preset time selected and count down
• An LED indicates when the timer is about to turn off
•
Dimmed LED to act as a locator in the dark
• Easy programming mode with 1 minute increments
• Bypass mode that allows the timer to stay on permanently.
OPERATION INSTRUCTIONS
•
To turn on the load press any of buttons 1 through 5.
• Load will turn off either by pressing button 6 or after the selected time delay
• While the load is on, if any of buttons 1 – 5 are pressed, the timer resets to the selected time
• The LED will be updated as the timer counts down and indicates the approximate time remaining.
• The LED on button 6 will blink for one minute before the timer times out
Timer Bypass Mode
This mode is to allow the user to use the timer as a regular switch (no time out). To put the device in this mode, press and hold button 6 for 2 seconds until the LED on button 6 starts blinking and
then release the button. The load will turn on and stay on until the user momentarily presses button 6 again to turn it off.
Timer Programming Modes
The timers come pre-programmed but can be customized to very specific durations. To re-program the timer, there are 2 methods - a quick mode that sets predefined values to the timer, and an
advanced mode that allows the user to program each button separately.
Quick Programming Mode :
• Press and hold buttons 1 and 6 together for 5 seconds
• The LEDs on buttons 1 and 6 will start to blink alternately
• Release the buttons.
• LED will start to scroll indicating that the device is in the programming mode
• Press the desired set of values according to the choices shown below
• The scrolling LEDs will stop and the selected button LED will temporarily blink to indicate that the device programming has been completed.
Advanced Programming Mode (Minute and Hour timers):
• Press and hold buttons 5 and 6 together for 5 seconds
• The LEDs on buttons 5 and 6 will start to blink alternately
• Release the buttons
• LED will start to scroll indicating that the device is in the programming mode
• Press the button that will be programmed
• LEDs will stop scrolling and the selected button will start to blink
• The user will then press any combination of values corresponding to the table shown below that add up to the desired time delay:
Button 1 1 minute
Button 2 5 minutes
Button 3 10 minutes
Button 4 30 minutes
Button 5 60 minutes
Example: If the user wants to program a value of 17 minutes, press button 3 once, button 2 once and button 1 twice (10+5+1+1).
• Press the button 6 to finish programming. The LED on button 6 will temporarily blink to indicate that programming has been completed.
• The same process should be repeated for each button to be programmed.
SSIINNGGLLEE OOUUTTPPUUTT —— 55 BBUUTTTTOONN TTIIMMEERR IINNSSTTRRUUCCTTIIOONNSS
TIMER-PTA (REV. A)
ENGLISH IN U.S.A.: Cooper Wiring Devices, 203 Cooper Circle, Peachtree City, GA 30269 • 866-853-4293
Minute Timer (9590 & PT18M)
Button 1 5, 10, 15, 30, 60 minutes (default)
Button 2 5, 10, 20, 30, 60 minutes
Button 3 5, 15, 30, 45, 60 minutes
Button 4 1, 5, 10, 15, 30 minutes
Button 5 1, 10, 15, 20, 30 minutes
Hour Timer (9591 & PT18H)
Button 1 1, 2, 4 , 8, 12 hours (default)
Button 2 1, 3, 6, 9, 12 hours
Button 3 2, 4, 8, 12, 24 hours
Button 4 30m, 1, 2, 4, 8 hours
Button 5 15m, 30m, 1, 2, 4 hours
Button 1
Button 2
Button 3
Button 4
Button 5
Button 6
LED
Indicators
(ASPIRE Model Shown)