User`s guide

Eaton
®
PowerPass
®
Distribution Module (2500/3000 VA) User's Guide S 164201798 Rev 2
www.eaton.com/powerquality
11
Chapter 2 Installation
This chapter describes:
S Equipment inspection
S Rackmount setup
S Low-voltage and high-voltage installation for plug-receptacle and
hardwired models
S Rear panels
S Load segments
Inspecting the Equipment
If any equipment has been damaged during shipment, keep the shipping
cartons and packing materials for the carrier or place of purchase and file
a claim for shipping damage. If you discover damage after acceptance,
file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with
the carrier within 15 days of receipt of the equipment; 2) Send a copy of
the damage claim within 15 days to your service representative.
PowerPass Distribution Module Setup
NOTE If you are installing the UPS for the first time, follow the instructions in the UPS
user's guide to set up the UPS and any optional Extended Battery Modules (EBMs). Do not
connect your equipment to the UPS or start up the UPS before installing the PowerPass
Distribution Module (PDM).
If the UPS is already installed and operating, prepare your equipment for
shutdown and use the following procedure to shut down the UPS:
1. Turn off the equipment that is connected to the UPS.
2. Press and hold the Off
button for approximately three seconds.
The UPS transfers to Standby mode (if utility power is available) and
removes power to your equipment.