Installation Manual

ManualsBrandsEaton ManualsPanel MountSp1 Type 1 Spd, 240d

Page 4 Eaton Corporation

4.0 Specications

Description Ratings

Surge current capacity per phase 50kA

Nominal Discharge Current (In)

20kA for SP1-240S, 208Y, 480Y, 240D, and 480D, 10kA for

SP1-600Y and 600D

Short circuit current rating (SCCR) 200kA

SPD type Type 1 (can also be used in Type 2 applications)

System voltages available (VAC)

Single split-phase 120/240

Three-phase wye 120/208, 277/480, 347/600

Three-phase delta 240, 480, 600

Protection modes

Single split-phase and three-phase wye L-N, L-L

Three-phase delta L-G, L-L

Maximum continuous operating voltage (MCOV)

SP1-240S and SP1-208Y 150 L-N, 300 L-L

SP1-480Y 320 L-N, 640 L-G

SP1-600Y 420 L-N, 840 L-G

SP1-240D 300 L-G, 300 L-L

SP1-480D 640 L-G, 640 L-L

SP1-600D 840 L-G, 840 L-L

Input power frequency 50/60 Hz

Enclosure rating NEMA 4

Operating temperature -20°C through 50°C (-4°F through 122°F)

Operating humidity 5% through 95%, noncondensing

Operating altitude Up to 16,000 ft (5000m)

Agency certiﬁcation and approvals UL1449 3rd Edition listed device

Warranty 2 years

to be defective. The giving of or failure to give

any advice or recommendations by Eaton shall

not constitute any warranty by or impose any

liability upon Eaton. The foregoing constitutes

the sole and exclusive liability of Eaton AND IS

IN LIEU OF ANY AND ALL OTHER WARRAN-

TIES EXPRESSED, IMPLIED OR STATUTORY

AS TO THE MERCHANTABILITY, FITNESS

FOR PURPOSE SOLD, DESCRIPTION, QUAL-

ITY, PRODUCTIVENESS OR ANY OTHER

MATTER. In no event shall Eaton be liable for

special or consequential damages or for delay

in performance of the warranty. This warranty

does not apply if the product has been misused,

abused, altered, tampered with, or used in appli-

cations other than specied on the nameplate.

At the end of the warranty period, Eaton shall be

under no further warranty obligation expressed

or implied. The product covered by this warranty

certicate can only be repaired or replaced by

the factory. For help on troubleshooting the

SPD, or for warranty information, call 1-800-

809-2772, Option 4, sub-option 2. Repair or re-

placement units will be returned collect. If Eaton

nds the return to be a manufacturer’s defect,

the product will be returned prepaid.

Eaton Corporation

Cutler-Hammer Business Unit

1000 Cherrington Parkway

Moon Township, PA 15108-44312

USA

http://www.Eaton.com

For Technical Support please call:

1-800-809-2772

5.0 Warranty

Eaton warrants these products for a period of 2

years from the date of delivery to the purchaser

to be free from defects in both workmanship

and materials. Eaton assumes no risk or liability

for results of the use of the products purchased

from it, including but without limiting the gener-

ality of the foregoing: (1) The use in combination

with any electrical or electronic components,

circuits, systems, assemblies, or any other

materials or substances; (2) Unsuitability of any

product for use in any circuit or assembly. Pur-

chaser’s rights under the warranty shall consist

solely of requiring Eaton to repair, or at Eaton’s

sole discretion, replace, free of charge, F.O.B.

factory, and defective items received at said

factory within said term determined by Eaton