Instruction manual

MAINTAINING THE UPS SYSTEM
Eaton
®
9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual S 164201603 Rev 4 www.eaton.com/powerquality
13-3
13.2.4 Battery Maintenance
NOTE DO NOT DISCONNECT the batteries while the UPS is in Battery mode.
Contact your Eaton service representative for battery maintenance. Battery
replacement and maintenance should be performed only by authorized service
personnel.
13.3 Recycling the Used Battery or UPS
Contact your local recycling or hazardous waste center for information on proper
disposal of the used battery or UPS.
W A R N I N G
S Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper disposal of batteries is
required. Refer to your local codes for disposal requirements.
S Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes. It
may be toxic.
C A U T I O N
Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead‐acid batteries
and must be disposed of properly. For more information, contact your local recycling/reuse or hazardous
waste center.
C A U T I O N
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal, contact your
local recycling/reuse or hazardous waste center.
13.4 Maintenance Training
A basic training course, available from Eaton, gives you a competent working
knowledge of the UPS system operation and teaches you how to perform first level
corrective maintenance. For more information about training and other services,
contact the Eaton Help Desk (see page 1-8).