Instruction manual

INSTALLING THE UPS SYSTEM
Eaton
®
9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual S 164201603 Rev 4 www.eaton.com/powerquality
4-9
NOTE In the following step the pallet tilts and acts as a ramp once the cabinet is rolled beyond the center
of the pallet. Be sure to restrain the cabinet as it continues to roll down the pallet/ramp.
W A R N I N G
Do not stand directly in front of the pallet while unloading the cabinet. If unloading instructions are not
closely followed, the cabinet may cause serious injury.
10. Slowly roll the cabinet toward the front of the pallet. Once the pallet tilts,
continue rolling the cabinet down the pallet until the cabinet is clear of the pallet.
11. After the cabinet is clear of the shipping pallet, remove the long angle bracket
from the pallet. Secure the long angle bracket to the left side of the cabinet as an
anti-tip measure when rolling the cabinet to its final location.
12. Roll the cabinet to the final installation location.
13. If installing the cabinet permanently, reuse the shipping brackets and hardware;
otherwise, discard or recycle the pallet and brackets in a responsible manner.
14. If permanently mounting the system, proceed to Step 18; otherwise, continue to
Step 15.
W A R N I N G
The front and left side anti-tip/shipping brackets must be reinstalled; otherwise, injury to personnel and
damage to the UPS may result when removing components during service. If the brackets are not reinstalled,
the cabinet may tip and cause serious injury to personnel and damage to equipment.
15. Secure the UPS cabinet in position by lowering the leveling feet until the cabinet
is not resting on the casters and the cabinet is level.
16. Using the retained hardware, reinstall the front anti-tip/shipping bracket (bracket
with wider base) removed in Step 3 to the front of UPS cabinet with the angle
facing outward and adjusted level with the floor (see Figure 4‐1).
17. If installing distribution or accessory cabinets, proceed to paragraphs 4.4 and 4.5;
otherwise, proceed to paragraph 4.7.
18. Using the retained hardware, reinstall the shipping brackets removed in Step 5 to
the front and rear of the UPS cabinet with the angle facing outward (see
Figure 4‐1 and Figure 4‐2).
19. Secure the cabinet to the floor with customer-supplied hardware.
20. If installing distribution or accessory cabinets, proceed to paragraphs 4.4 and 4.5;
otherwise, proceed to paragraph 4.7.
4.3 Battery Cabinet Installation
NOTE This procedure does not apply to the 9390IT internal battery configuration.
To install the battery cabinet, refer to the Eaton 9390 Integrated Battery Cabinet
(Models IBC-S and IBC-L) Installation Manual. After the battery cabinet is installed,
return to paragraph 4.7 to wire the UPS and battery cabinet.