Specifications

Page 35 of 89
4.5 Assigning Inputs
Inputs may be assigned by double-clicking the name of an Array. This opens the Input
Configuration dialog box where you can select how you will feed audio to the Anya
System. Following are the available options based on the Mode you select
Mode
Master
Dante Source
Dante Channel
None
N/A
N/A
N/A
Analog
Select which physical Module is
receiving the analog audio signal
N/A
N/A
AES L
Select which physical Module is
receiving the AES/EBU audio signal
(left AES channel).
N/A
N/A
AES R
Select which physical Module is
receiving the AES/EBU audio signal
(right AES channel).
N/A
N/A
Net
N/A
Select which device, typically
the house console or Dante on-
ramp device
Select either the
Main or Aux
Channel
Net
Aux
N/A
Select which device, typically
the house console or Dante on-
ramp device
Select either the
Main or Aux
Channel
*Note: You may receive a yellow banner with a warning that “Network settings out of sync:
one or more input modes out of sync.” with Dismiss and Select Inputs buttons, or Dismiss and
Sync Now buttons (depending on which parameters are out of sync). Clicking Select Inputs
opens the Input Configuration dialog box, allowing this parameter to be confirmed for all
modules. Clicking Sync Now synchronizes the EQ and processing parameters for all modules
with the Resolution model.
WARNING: IT IS CRITICAL THAT ALL PARAMETERS ARE SYNCHRONIZED FOR ANYA TO
FUNCTION PROPERLY. LISTENING TO ANYA ARRAYS WITHOUT FULLY SYNCHRONIZED
PARAMETERS OR WITH NETWORK ERRORS MAY PRODUCE UNEXPECTED
ACOUSTICAL RESULTS AND IS NOT RECOMMENDED.