FCC ID : VASEBP200B ATTACHMENT E. - USER MANUAL - HCT CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
Payment Terminal User’s Manual Ver 1.
INDEX 1. POWER AND NETWORK CABLE........................................................................................................3 1.1 POWER INPUT ......................................................................................................................................3 1.2 HOW TO CONNECT POWER ..................................................................................................................3 1.3 HOW TO CONNECT NETWORK CABLE ...............................................
1. Power and Network Cable 1.1 Power Input INPUT VOLTAGE : AC 110V/220V (50~60Hz) CABLE : UL 2464-3C 16AWG TERMINAL : RING TYPE 1.
TERMINAL BLOCK Open the door on the frontside of the Payment Terminal to find the power panel toward the lower mid-section. Connect the AC input power cable to the terminal block inside the power panel. Terminal Block Description Pin Number 1 INPUT AC 2 INPUT AC 3 F.
1.3 How to Connect Network Cable RJ45 Coupler RJ45 Coupler Position Connect network cable (ETHERNET,Category-5) to RJ45 coupler Middle door on the front of the Payment Terminal.
1.
2. RF Card Operation 2.1 RF Card Specification Contactless Philips Mifare 14443 Type A Card are accepted이다 ASK 100 % , 106kbs Carrier frequency 13.56 MHz 1024 Bytes EEProm 2.2 Payment Terminal Operation User tags the RF card to pass the Payment Terminal. User can confirm card balance and the current fare deducted through the display at the Payment Terminal. The Payment Terminal operates only normal mode. In normal mode, card is used to operate the Payment Terminal typically. 2.
3.
User’s Information 1. Cautions Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. FCC compliance Information This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received. Including interference that may cause undesired operation. 3.
