Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 DD200 INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL www.eipl.co.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 DD200 PACKAGE CONTENTS Item Description Quantity 10502SS-US Dehumidifier 1 3033807 Free plug 1 TPC356 Manual 1 Page 2 of 15
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 UNPACKING Carefully remove the DD200 dehumidifier unit from its transit box and visually check for signs of transit damage. If there is evidence of damage DO NOT attempt to operate the unit, call your supplier for advice. Do not discard the packing, it will be useful when transporting the dehumidifier unit in the future. INTRODUCTION Dehumidifiers remove moisture from the air that is circulating through the unit.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 SPECIFICATIONS MODEL: DD200 HEIGHT: 13.3” (340mm) WIDTH: 13” (330mm) DEPTH: 15” (380mm) WEIGHT: 37.5 lbs (17 Kg) DRY AIRFLOW: 115CFM (196 M³/HR) WET AIRFLOW: 38CFM (64 M³/HR) POWER SUPPLY: 115V, 1 ph, 60Hz POWER 0.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 INSTALLATION POSITIONING: The DD200 is designed for indoor use. Position the dehumidifier unit in the center of the room to be conditioned if at all possible. NOTE: Both the air inlets and outlets of the dehumidifier unit must have clear space around them and not be obstructed in anyway. DUCT CONNECTION The wet air outlet from the dehumidifier must be exhausted to outside of the room being dried by means of a suitable duct.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 OPERATION The electrical controls are located on the front of the unit. They are: • • ON / OFF Switch 0 Dehumidifier OFF 1 Dehumidifier ON Humidity Switch M Dehumidifier in continuous operation A Dehumidifier operation by means of an external humidistat • An ammeter is provided to display the current used by the unit.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 AIR MOVING SYSTEM: The DD200 is a single fan balanced system providing both the “Process” air and “Regeneration” air flow. As the air passes over the rotor, it will be heated as a result of the regeneration cycle. The air leaving the unit will be hotter than the air entering During normal operation some parts of the dehumidifier may become hot. This is normal.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 SAFETY -WARNING♦ DO NOT ALLOW CHILDREN TO PLAY WITH OR AROUND THE UNIT. ENSURE THE UNIT IS INACCESIBLE TO CHILDREN WHEN NOT ATTENDED.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 ROUTINE MAINTENANCE & REPAIR WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE MAINTENACE. SWITCH OFF THE DEHUMIDIFIER APPROXIMATELY 15 MINUTES PRIOR TO REMOVING ANY PANELS, ALLOWING THE HEATER TO COOL DOWN To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: • We recommend that the filter is checked at least once a month.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 IF ANY OF THE PRECEDING PROBLEMS OCCUR, CONTACT THE EBAC INDUSTRIAL PRODUCTS LTD SERVICE CENTER PRIOR TO CONTINUED OPERATION OF THE UNIT TO PREVENT PERMANENT DAMAGE.
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 SPARE PARTS LIST DESCRIPTION PART NUMBER Process Air Fan Motor 3040261 Capacitor for Process Air Fan Motor 3030891 Process Inlet Filter 2050114 Drive Motor 3040260 Capacitor for Drive Motor 3030875 Pulley 3050556 Pulley Belt 3050555 PTC Heater 3031626 Overheat Protector 3477026 Desiccant Wheel 3020708 PCB Controller 1619600 Mains Cable 3035148 On / Off Switch 3030557 Auto / Manual Switch 3030522 Ammeter 3180100 Hour Counter 30
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 Page 12 of 15
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 Page 13 of 15
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 Page 14 of 15
Drawing : - TPC 356 Issue :-7 Date : - 10/12/13 UK Head Office American Sales Office German Sales Office Ebac Industrial Products Ltd St Helens Trading Estate Bishop Auckland County Durham DL14 9AD Ebac Industrial Products Inc 700 Thimble Shoals Blvd. Suite 109, Newport News Virginia, 23606-2575 USA Ebac Industrial Products Ltd. Gartenfelder Str.
