Manual

Figure 5. Cartridge Seal Assembly

CAUTION!

This seal is not designed for operation at

temperatures above 160 º F (71º C). Do not use

at higher operating temperatures.

If the seal plate was removed, install the seal plate

gasket (4). Position the seal plate over the shaft and

secure it to the bearing housing with the hardware.

To prevent damaging the shaft sleeve O-ring on the

shaft threads, stretch the O-ring over a piece of

tubing 1-1/4 I.D. x 1-1/2 O.D x 2 inches long (32mm

x 38mm x 51mm).

SEAL PLATE

O-RINGS

SLEEVE

O-RING

INTEGRAL

SHAFT

SLEEVE

SHEAR

RING

(SHEARED)

STATIONARY

SEAT

STATIONARY

ELEMENT

ROTATING

ELEMENT

DRIVE BAND

SPRING

CENTERING

WASHER

BELLOWS

IMPELLER

SHAFT

IMPELLER

SHIM S

IMPELLER

SPRING

RATAINER

EBARA Fluid Handling