Other

ManualsBrandsEbern Designs ManualsLightingJollette White 1 -Light Hardwired Lantern Head

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully.

If you are unclear as to how to proceed,

consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

fixture.

Hold fitter (A) in an upright position. Push fixture screws (B) up

through holes in fitter bottom, heads down.

(Steps 1 and 2 may be factory installed).

FIGURE 1

STEP 1:

WARNING

NOTE: DO NOT INSTALL ON A POST OR A POLE THAT

RESULTS IN A VERTICAL RISE OF 25 FEET OR HIGHER.

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

Drop springs (C) on screws (B) and thread into retaining plates (D),

by turning screwhead (B).

STEP 2:

Drop hex nut (H) into slot groove of the fitter (A). Thread screw (E)

into hex nut (H) on the inside of the fitter (A).

STEP 3:

*NOT SUPPLIED

GLOBE (G)

RETAINING

PLATE (D)

HEX

NUT (H)

SCREW

HOLE (F)

FITTER (A)

* WIRE

CONNECTOR

* POST

FIXTURE

SCREW (B)

SCREW (E)

SPRING (C)

CAUTION:

Fixtures with photo-cells should be mounted at least 48”

from all sides to avoid reflection of light back onto Photo-cell,

causing the Photo-cell to malfunction or flicker.

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF . (Steps 1 and 2 may be factory installed). STEP 1: Hold fitter (A) in an upright position. Push fixture screws (B) up through holes in fitter bottom, heads down. GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
PAGE 2
INSTALLATION STEP 2: STEP 1: A. Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below: GROUND INSTRUCTIONS: Connect the ground wire from the fixture (bare metal or green insulated wire) to the ground wire from the power supply (bare metal or green insulated wire) using a small wire connector (not supplied). NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES.