**WARNING: READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE.
TABLE OF CONTENT IMPORTANT INSTRUCTIONS 03 SPECIFICATIONS 05 SAFETY FEATURE IN THE BOX PRODUCT DIAGRAM 06 06 CONTROL PANEL 07 REMOTE CONTRAL 07 POWER OUTLET 08 WLL-MOUNTED INSTALLATION GUIDE LINES 08 WALL-MOUNTED INSTALLATION- DIAGRAMS 09 WALL-MOUNTED INSTALLATION INSTRUCTIONS 10 OPERATION INSTRUCTIONS 11 MAINTENANCE 11 STORAGE 12 TROUBLE SHOOTING 2 05 12
IMPORTANT INSTRUCTIONS When using this electric unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. 2.
17. Do not run the mains cable under carpets, rugs etc. 18. Do not allow the mains cable to hang over sharp edges or come into contact with hot surfaces. 19. WARNING: In order to avoid overheating, do not cover or obstruct the heater in any way. 20. Overheating will result if it is accidentally covered. 21. Never immerse the product in water or any other liquids. 22. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. 23. Do not use the appliance outdoors. 24.
SPECIFICATIONS Voltage Rating 120 V ~ 60Hz Power Consumption 1500W Unit Size 33.46 in. (W) x 3.74 in. (D) x 25.59 in. (H) 25.98 in. (W) x 3.74 in. (D) x 20.47 in. (H) SAFETY FEATURE OVERHEAT SAFETY FEATURE This heater is fitted with a safety cut-off which will operate if the fire overheats (e.g. due to blocked air vents). For safety reasons, the fire will NOT automatically reset. To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
IN THE BOX • A: ELECTRIC FIREPLACE • B: REMOTE CONTROL (NOT INCLUDE BATTERIES) • C: ROCK • D: 1 LARGE WALL-MOUNTING BRACKET • E: SIX SCREW EXPANSION TUBES • F: 2 SMALL BLACK SCREWS • G: SIX LONGER BLACK SCREWS • H: 1 SMALL BRACKET • I: INSTRUCTION MANUAL PRODUCT DIAGRAM Air outlet Control panel Glass Rock 6 Power switch
CONTROL PANEL The control panel is located on the top right hand side of the fireplace. Power switch: Power switch of the fireplace REMOTE CONTROL When using the remote control to operate the flame effect heater, please ensure you have properly inserted two AAA batteries, the remote control directly towards the front of the fireplace. The remote control will not operate if its path is blocked. Make sure there are no obstacles between the fireplace and the remote control.
POWER OUTLET The heater can be wall-mounted, which can be used in the living room or bedroom. Plug the unit into a 120 V 60 Hz electrical outlet, and open the switching power supply. WALL-MOUNTED INSTALLATION GUIDE LINES Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location be sure to follow the general instructions included. For best results install out of direct sunlight.
WALL-MOUNTED INSTALLATION- DIAGRAMS 9
WALL-MOUNTED INSTALLATION INSTRUCTIONS The fire must not be used until it is securely fastened to the wall. Do not connect the appliance to the mains until properly fixed to the wall and the instructions are read fully. The minimum distances must be observed in the diagrams. For installation of the appliance, care must be taken not to damage concealed cables. Please be careful whilst drilling holes. 1. This appliance is designed to be permanently fixed to a wall at a minimum height of 300mm.
OPERATING INSTRUCTIONS 1. Firstly, turn on the power switch at the top right hand side of the fireplace, which can provide the power supply to all the function of the fireplace. Only in the state of mode I, the function will be operated, including the using of remote control. 2. Turn on the fireplace and fireplace flame effect O/I ON/OFF Press the O/I button on the fireplace once to turn on the appliance and fire effect.
MAINTENANCE - LED SYSTEM This product does not use a standard bulb for its flame effect. The appliance uses an electronically controlled LED system to create the effect, therefor no parts need to be replaced. There are no user-serviceable parts on this appliance. Under no circumstances should the appliance be serviced be anyone other than a qualified electrician. STORAGE Store the heater in a cool, dry location when not in use.