Instruction Manual

10
WALL-MOUNTED INSTALLATION INSTRUCTIONS
The fire must not be used until it is securely fastened to the wall.
Do not connect the appliance to the mains until properly fixed to the wall and the
instructions are read fully.
The minimum distances must be observed in the diagrams.
For installation of the appliance, care must be taken not to damage concealed cables.
Please be careful whilst drilling holes.
1.
This appliance is designed to be permanently fixed to a wall at a minimum height of
300mm.The wall bracket must be fitted horizontally and the cable routed to the
bottom right of the heater.
2.
A distance of 600mm from bottom of heater to floor is recommended for optimum
viewing of fuel bed.
3.
For optimum viewing, mark the top four screws fixing positions on wall in accordance
with the recommend fixing dimensions.
4.
Drill holes with a No. six drill bit.
5.
Fix the wall bracket using that the plug and screws provided.
6.
Attach the lower fixing bracket the base of the fire using the two small black screws
supplied; ensure the bracket is fitted so that it is level with the back.
7.
Carefully lift the heater up ensuring that the top rear ledge of heater engages with the
wall bracket and is sitting centrally. This process should be carried out by two people
to avoid injury or damage to property or the appliance.
8. Gently bring the heater down against the wall.
9.
Mark the lower fixing bracket two fixing hole positions on the wall, remove the heater.
10.
Drill the wall and insert the wall plugs.
11.
Refit the heater to the wall and fasten the bottom fixing bracket to the wall using the
screws provided to permanently fix the heater in place.
12.
Unpack the pebbles from the bag and place them along the light unit in the desired
position.
13.
Place the front surround over the front of the fire aligning the slots in the brackets at
each side of the front panel with the lugs on the sides of the fire. Again two people
will be required for this operation.