Manualshelf

Instruction Manual

ManualsBrandsEbern Designs ManualsFurnitureBartlow Wall Mounted Electric Fireplace
3456789101112
11
OPERATING INSTRUCTIONS
1.
Firstly, turn on the power switch at the top right hand side of the fireplace, which can
provide the power supply to all the function of the fireplace. Only in the state of mode I, the
function will
be operated, including the using of remote control.
2.
Turn on the fireplace and fireplace flame effect
O/I
Press the O/I button on the fireplace once to turn on the appliance and
fire effect. A red indicator light will show to indicate that the fire is ON
ON/OFF
Press the ON/OFF button on the remote control once to turn on the
appliance and fire effect. A red indicator light will show to indicate that
the fire is ON.
3. ADJUST THE FLAME BRIGHTNESS
O/I
Press the O/I button on the fireplace for 3 seconds, this will operate
the dimmer mode, hold the button down until the desired brightness is
obtained.
DIMMER
Press the DIMMER button on the remote for operate the dimmer
mode. There will be 5 setting, press the button again and again until
the the desired brightness is obtained.
4. 750W heating
750W
Press once the 750W button on the fireplace or the remote control for
the low heat settings; press twice to switch off the heat setting.
5. 1500W heating
1500W
Press once the 1500W button on the fireplace or the remote control
for the high heat settings; press twice to switch off the heat setting.
MAINTENANCE
1.
Turn off the heater of the power switch.
2.
Unplug the unit and let it cool completely.
3.
To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may
use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION:
DO
NOT let liquid enter the heater.
4.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean
the heater. This may cause damage or deterioration to the surface of the heater.
5.
DO NOT immerse the heater in water.
6.
Wait until the unit is completely dry before use.
7.
If won’t use the unit for a long time, please take out battery in remote control, then take
care of the remote control.