Instruction Manual

7
CONTROL PANEL
The control panel is located on the top right hand side of the fireplace.
Power switch: Power switch of the fireplace
REMOTE CONTROL
When using the remote control to operate the flame effect heater, please ensure you have properly
inserted two AAA batteries, the remote control directly towards the front of the fireplace. The
remote control will not operate if its path is blocked. Make sure there are no obstacles between the
fireplace and the remote control. If the heater does not work when using the remote control from a
close range, you need to replace the batteries.
NOTE: Please be patient when using the remote control. It takes a little time for the receiver to
respond to the transmitter. Do not press any button more than once within two seconds for the
heater to operate normally.
Turn on/off the fireplace and the flame
To adjust the flame brightness for 5 setting, press
the button again and again, until the desired
brightness is obtained.
Turn on/off 1500W heating
Turn on/off 750W heating