Manualshelf

Assembly And Installation Instructions

ManualsBrandsEbern Designs ManualsCeiling LightsBoehmer 1 - Light Simple Bowl LED Flush Mount
12
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Mounting Strap (A)
Green Grounding
Screw (C)
Long Screw(D)
Mounting Screw (B)
Wire Connector (E)
Turn on the power at fuse or circuit box
Outlet Box
House Grounding Wire
Wire Connector(E)
Long Screw(D)
Ceiling Pan
Stud
LED Module
Slot
Plastic Shade
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Fig.1
Long Screw
Key Hole Slot
Installation Steps
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
1. Attach the two long screws to the holes on the mounting
strap. Thread them in part way: 2 to 3 turns only.
2. Attach the mounting strap to the outlet box using two
mounting screws.
3. Pull out the source wires from the outlet box.
Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation)
from the fixture to the black wire from the
power source.
---Connect the neutral wire (usually white
insulation) from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire (usually
green insulation or bare wire) to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with
the wire connectors.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes. Rotate the ceiling
pan until it is locked into place, and then tighten the long screws to secure it. (See Fig.1)
5. Attach the plastic shade to the ceiling pan by aligning studs and slots, and turn it clockwise until it is locked in place.
Caution: To prevent electrostatic discharge (ESD) damage to the module electronics, do not touch the LED

Summary of content (2 pages)