Installation & Assembly

ManualsBrandsEbern Designs ManualsFurnitureNathanson Mesh Task Chair

Table Of Contents

PARTS LIST

ATTENTION: Before you begin to assemble the product, please make

sure that all the parts are included in the package, and

inspect them for damages or defects.

(A)x1

Backrest

(B)x1

Seat

(C)x1

Base

(D)x1

Mechanism

(E)x1

Gas Lift

(F)x5

Casters

(G)

1 Right, 1 Left

ARMS

(H)x4

Screws M6x25mm

(J)x4

Screws M6x35mm

Washer

(I)x4

Screws M6x20mm

(K)x4

Cap Cover

(L)x1

Allen key

ASSEMBLY INSTRUCTIONS CHAIR STYLE

Insert all the casters(F)

into the base (C) using

pressure, then place

the gas lift (E) in the

middle of the base (C).

Assemble the arms (G)

to the backrest (A) on

their respective sides

using screws (H) and

cover the holes with

caps (K).

Assemble the arms (G) to

the seat (B) using screws

and washers (J) as

shown.

ATTENTION:

- To avoid misalignments, leave the screws

loose and do not tighten them until all are

in place.

- Do not overtighten or force the screws as they

could break or strip.

- Using the wrong size of screws on a part might

cause damage to it.

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

Install the mechanism (D)

under the seat B and

attach it with screws (I).

Make sure the tension

knob is facing towards the

front of the seat and the

lever/handle is on the

right side of the chair.

Place the top parts of the

chair over the base parts

making sure the gas lift

enters into the center

hole of the mechanism.

The top and base parts

will stay together by

pressure after seating.

Summary of content (2 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS CHAIR STYLE PARTS LIST ATTENTION: Before you begin to assemble the product, please make sure that all the parts are included in the package, and inspect them for damages or defects. (A)x1 Backrest (B)x1 Seat (G) ARMS 1 Right, 1 Left (H)x4 Screws M6x25mm ATTENTION: STEP 3 - To avoid misalignments, leave the screws loose and do not tighten them until all are in place. - Do not overtighten or force the screws as they could break or strip.
PAGE 2
LIFT AND TILT FUNCTIONS: - To raise or lower the chair’s height: Pull the handle UP with force. The chair will go down while sitting on it, or up if you lift your body. - Tilting mechanism: Pull the handle OUT (horizontally) to unlock and IN to lock. - Tilt tension control: Turn the mechanism’s knob either direction to apply more or less tension to the tilting function. WARNINGS: - Do not stand up on the chair. - Do not use the chair as a ladder. - Use for seating only one person at a time.