Installation Guide

Important: Before placing the shade into
the brackets, make sure the fabric is
rolled up evenly and the chain connector
is positioned on the rear-side chain and
resting against the clutch.
❶ Place the pin end (left side) of the shade into the round hole of the bracket.
❷ Keeping the pin end secure in its bracket, position the clutch into the bracket so the hooks fit securely into the
slots.
❸ Once the hooks are through the slots, gently pull down on the clutch until the hooks have locked securely in place.
❶ ❷
❸
Step 2-Install the Shade
❶ Mark the location for the clutch side (right side) bracket with a pencil and
mount the bracket using two screws.
❷ Insert the shade into the mounted bracket by sliding the hooks into the slots.
❸ Fit the pin-end bracket onto the round spring pin-end plug (left side) while
making sure shade is level. Press the bracket in at least 1/8” for necessary
pressure on the pin.
❹ Mark the bracket location and remove shade. Mount the bracket using two
screws.
OUTSIDE MOUNT
❶ ❷ ❸
❹
Clutch (Chain) Operated Roller Shades Installation Guide
Page 2