Installation Guide

The chain connector on the back of the chain will prevent the roller shade from
being raised past its limit. In order to prevent the shade from being lowered past
the ordered length, we have provided plastic stop balls that are easily snapped
onto the chain. (Note: Additional material has been added to the ordered length
to prevent exposure of the roller tube).
Roll the shade down to window sill or desired down limit.
❶ Attach a plastic stop ball to the highest point of the chain at the front of the
clutch. This will prevent the shade from being lowered past the down limit.
Page 3
❶
The chain tension device is required to be installed to comply with child safety standards. It is essential to use
this device to reduce the hazards of entanglement and strangulation by limiting access to the control chain.
Lower the shade and position the safety tension device on
the window frame or wall, so that the tension device does
not interfere with the shade operation. The tension device
should be positioned at the bottom of the chain loop and
the chain should be taut on both sides.
Attach the tension device using the screws provided. The
chain should pass through the tension device smoothly.
Roll the shade up and down several times. If the fabric shifts on the
roller noticeably to either side, you can correct the problem as follows:
Fabric shifts toward the left: Lower the shade fully until the aluminum roller tube is exposed.
Place a small piece of tape (masking tape works well) approximately 1 1/2” long near the right
edge of the roller (see illustration). Test the shade and add additional layers of tape as needed.
Fabric shifts toward the right: Lower the shade fully until the aluminum roller tube is exposed.
Place a small piece of tape (masking tape works well) approximately 1 1/2” long near the left
edge of the roller (see illustration). Test the shade and add additional layers of tape as needed.
Test the Shade
The shade can be cleaned using water or a mild soap solution. Brush lightly with a soft
cloth. Do not use any solutions containing chemicals. Let the shade dry before rolling it up.
Step 3-Install the Safety Tension Device
Maintenance & Care
Clutch (Chain) Operated Roller Shades Installation Guide