Assembly and Installation

4/28/09
cabinet.
drawers from being pulled out of the
SHEET 1 OF 1
Open one drawer at a time and empty 1.
the drawer of its contents. Close the
drawer after it is empty. Empty the
cabinet of all its contents.
IMPORTANT! All the contents must be
removed from the cabinet.
Open the second drawer from the 2.
bottom. Locate the two tabs on the left
and right drawer sides. Use a flathead
screwdriver to bend both tabs back
toward the inside of the cabinet. (Fig. A)
Repeat step #2 for the third drawer from 3.
the bottom.
Remove the second and third drawers 4.
from the cabinet.
Locate the two hidden holes on the 5.
inside of the cabinet. (Fig. B)
Insert both ends of the cross wire into the 6.
two hidden holes located on the left
and right sides of the cabinet. Push the
cross wire completely into the holes (Fig.
B)
Reinstall all the drawers in the cabinet.7.
IMPORTANT! Bend all the tabs located 8.
on the left and right drawer sides back
toward the outside of the cabinet. The
tabs must be bent out to prevent the
Cross Wire Installation
Cross Wire
Hole
Hidden
Cross Wire
Hole
Hidden
Cross Wire
Figure A
Tab
Figure B