Manual

Possible installation positions

The heater is preferably installed in the normal

position as shown in the drawing.

Depending on the installation conditions, the heater

can be tilted by max. 30° (flow direction to the bottom)

or turned by max. 90° around its own longitudinal axis

(exhaust connection horizontal, glow plug points

upwards!).

Normal position horizontal (exhaust connection

downwards) with tolerable swivel range

Cable harness connection, right or left

If necessary, the cable harness connection can be

changed over to the other side of the heater. To do

so, the controller has to be removed and the lower

semi-circular cable harness cover unclipped.

The cable harness can then be rerouted in the

controller.

Then mount the controller again, position the jacket

shell and insert the cable harness bush and the bungs

in the corresponding recesses in the lower jacket

shell.

 Heater air intake opening (fan wheel)

 Position of the glow plus

 Direction of flow

In the heating mode, the heater can deviate from the

shown normal or maximum installation positions by up

to +15° in all directions because of a slanting position

of the vehicle or boat, without any impaired functions.

Installation