Technical data

21
 Troubleshooting4
TP5 radio remote control
(OrderNo:221000320100)
Iffaultsoccurwhiletheheaterisrunning,theyaredisplayed
with“Err”afterthemobileunitisactivated.
Afterthediagnosticscable(bl/ws)hasbeenconnectedand
thefirstlogshavearrivedatthestationaryunit,thediagnose
canbecarriedoutusingthemobileunitoftheTP5radio
remotecontrol.
Thecurrentfault“F0”isdisplayed.Thestoredfaults“F1”to
“F5”canbequeried.
• Inordertocarryoutthediagnosis,thediagnosticscable
(bl/ws)mustbeconnectedtothestationaryunitandthe
heatercableharness.Tothisend,pleaserefertoandfollow
thecircuitdiagramfortheTP5radioremotecontrolandthe
heater.
• Ifthediagnosticscable(bl/ws)isnotconnected,the“Diag-
nosis”menuisblocked.
• Notonlythedefectivecomponent,butalsoadefectivecur-
rentcircuitresultsinafaultbeingdisplayed.
• InheaterswithconnectedairpressuresensortheTP5radio
remotecontrolcannotbeusedtoperformdiagnoses.The
diagnosticsunitortheEDiTHdiagnosticstoolmustbeused
toperformthediagnosis.
 Thefaultmemoryofthe„airpressuresensor“canberead
outusingtheEDiTHdiagnosticstoolonly.
• Faultcode,faultdescription,cause/remedialactionare
describedonPages23–27.
 Buttontoactivate/deactivatethemobileunit
 Buttonforforwardtimesetting
 Buttonforbackwardtimesetting
 Buttonforactivatingthepossiblesettings
 Buttonforswitchingheat/ventilateON/OFF;
 Activate/deactivatepreselectedtime
Enquire / delete fault memory
Usethe
keytoactivatethemobileunit.
Switchontheheaterwiththe
key.
Pressthe
keytwicetoopentheTimesettingmenu–
thetimeflashesinthedisplay.
Pressthe
keyforapprox2sec–untilthefollowingap-
pearsinthedisplay:
Press
key.
Press
key.
Press
keytwice.
Press
key.
Malfunctioninheater: Heaterhasnomalfunction:
Usethe
and buttonstocallupthefaultmemoryposi-
tions1to5.
Delete fault memory /
Cancel the control box lock
Usethe
keytodeletethefaultmemory.
Toconfirm,pressthe
keyforapprox2secuntil lights
upinthedisplay–faultmemoryisdeleted.
Please note!