Owner manual

Operating instructions
A6E560-AK01-01
Translation of the original operating instructions
3.2 Nominal data
Motor M6E110-EF
Phase 1~
Nominal voltage / VAC 230
Frequency / Hz 50
Type of data definition ml
Valid for approval /
standard
CE
Speed / min
-1
895
Power input / W 410
Current draw / A 1.8
Motor capacitor / µF 10
Capacitor voltage / VDB 400
Max. back pressure / Pa 85
Min. ambient temperature
/ °C
-40
Max. ambient
temperature
/ °C
65
Maximum safe operating
speed / min
-1
1650
@ 70 °C
ml = Max. load · me = Max. efficiency · fa = Running at free air
cs = Customer specs · cu = Customer unit
Subject to alterations
3.3 Data according to ErP directive
Installation category A
Efficiency category Static
Variable speed drive No
Specific ratio
*
1.00
*
Specific ratio = 1 + pfs / 100 000 Pa
Actual Request
2013
Request
2015
Overall efficiency ηes / % 27.3 27.2 31.2
Efficiency grade N 36.1 36 40
Power input Pe / kW 0.4
Air flow qv / m³/h 5080
Pressure increase total psf / Pa 79
Speed n / min
-1
900
Data definition with optimum efficiency.
The ErP data is determined using a motor-impeller combination in a standardised
measurement configuration.
3.4 Technical features
Mass 8.5 kg
Size 560 mm
Surface of rotor Cast in aluminium
Material of terminal box ABS plastic, black
Material of blades Aluminium sheet insert, sprayed with PP
plastic
Number of blades 5
Blade angle -5°
Direction of air flow "V"
Direction of rotation Counter-clockwise, seen on rotor
Type of protection IP 54
Insulation class "F"
Humidity class F3-1
Mounting position Shaft horizontal or rotor on bottom; rotor
on top on request
Condensate discharge
holes
Rotor-side
Operation mode S1
Motor bearing Ball bearing
Touch current acc.
IEC 60990 (measuring
network Fig. 4, TN
system)
<= 3.5 mA
Electrical leads Via terminal box, integrated capacitor
connected via terminal box
Motor protection Thermal overload protector (TOP)
brought out
Cable exit Axial
Protection class I (if protective earth is connected by
customer)
Product conforming
to standard
EN 61800-5-1; CE
Approval CCC; EAC; VDE
For cyclic speed loads, note that the rotating parts of the device
are designed for maximum one million load cycles. If you have
specific questions, contact ebm-papst for support.
3.5 Mounting data
; Secure the mounting screws against accidentally coming loose (e.g.
by using self-locking screws).
Strength class for
mounting screws
8.8
You can obtain additional mounting data from the product drawing if
necessary.
3.6 Transport and storage conditions
; Use the device in accordance with its protection type.
Max. permissible
ambient motor temp.
(transp./ storage)
+ 80 °C
Min. permissible
ambient motor temp.
(transp./storage)
- 40 °C
Item no. 10924-5-9970 · Revision 82543 · Release 2014-05-08 · Page 5 / 11
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone [phone] · Fax [phone] · [e-mail] · www.ebmpapst.com