User guide
34
6 Parameterisation
Parameterübersicht
Parameter
No. [hex]
Parameter
Name
Units min. max. Speicherklasse
0x49
Negative positioning window*
revolutions 0 65535
appl value
0x4A U
ZK
overvoltage threshold 10 mV 0 65535 appl value
0x4B U
ZK
undervoltage threshold 10 mV 0 65535 appl value
0x4C U
ZK
voltage hysteresis 10 mV 0 65535 appl value
0x4D Ballast chopper switching on threshold 10 mV 0 65535 appl value
0x4E Ballast chopper– switching off threshold 10 mV 0 65535 appl value
v4F Temperature signal threshold °C 0 110 appl value
0x50 Temperature signal delta hysteresis °C 0 110 appl value
0x51 Transmission ratio 1 65535 appl value
0x52 Bus address 1 127 appl value
0x8001 Current actual speed rpm appl value
0x8002 current electrical current, winding 10 mA appl value
0x8003 current actual position LoByte 1/65535 revolutions appl value
0x8004 current actual position HiByte revolutions appl value
0x8005 current actual temperature LP °C appl value
0x8006 current electrical current I
d
10 mA appl value
0x8007 current electrical current I
q
10 mA appl value
0x8008 Output status digital appl value
0x8009 Status of inputs: IN A, IN B, IN 1, IN digital appl value
0x800A not used
0x800B not used
0x800C not used
0x800D Analog IN 1 digits appl value
0x800E Analog IN 2 digits appl value
0x800F
Analog internal NTC
digits
appl value