Owner manual

Operating instructions
G4D180-FF20-01
Translation of the original operating instructions
3.2 Nominal data
Motor M4D074-DF
Phase 3~ 3~ 3~ 3~
Nominal voltage / VAC 230 230 400 400
Connection Δ Δ Y Y
Frequency / Hz 50 60 50 60
Type of data definition fa fa fa fa
Valid for approval /
standard
CE CE CE CE
Speed / min
-1
1330 1440 1330 1440
Power input / W 175 240 175 240
Current draw / A 0.68 0.75 0.39 0.43
Min. back pressure / Pa 0 0 0 0
Min. ambient temperature
/ °C
-25 -25 -25 -25
Max. ambient
temperature
/ °C
60 45 60 45
ml = Max. load · me = Max. efficiency · fa = Running at free air
cs = Customer specs · cu = Customer unit
Subject to alterations
3.3 Technical features
Mass 6 kg
Size 180 mm
Surface of rotor Coated in black
Material of impeller Sheet steel, galvanized
Housing material Sheet steel, galvanized
Direction of rotation Clockwise, seen on rotor
Type of protection IP 44
Insulation class "B"
Humidity class F5
Mounting position Any
Condensate discharge
holes
Rotor-side
Operation mode S1
Motor bearing Ball bearing
Touch current acc.
IEC 60990 (measuring
network Fig. 4, TN
system)
< 0.75 mA
Cable exit Variable
Protection class I (if protective earth is connected by
customer)
Product conforming
to standard
EN 60335-1; CE
Approval CCC
For cyclic speed loads, note that the rotating parts of the device
are designed for maximum one million load cycles. If you have
specific questions, contact ebm-papst for support.
3.4 Mounting data
For depth of screw, see chapter 3.1 Product drawing
; Secure the mounting screws against accidentally coming loose (e.g.
by using self-locking screws).
Strength class for
mounting screws
8.8
You can obtain additional mounting data from the product drawing if
necessary.
3.5 Transport and storage conditions
; Use the device in accordance with its protection type.
Max. permissible
ambient motor temp.
(transp./ storage)
+ 80 °C
Min. permissible
ambient motor temp.
(transp./storage)
- 40 °C
Item no. 10298-5-9970 · Revision 82662 · Release 2014-04-30 · Page 5 / 9
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone [phone] · Fax [phone] · [e-mail] · www.ebmpapst.com