User guide

31-5-2012 13 ebode VLHD30
* Failure 3: The distance between the transmitter and receiver are close, why 1
minute later the Network Link LED is still off?
Answer：Please check the frequency between the transmitter and receiver is set. Please
follow the frequency setting process to tune the frequency.
* Failure 4: The Network Link LED is on in the transmitter and receiver，but the
Video Link LED is off and the TV has no image?
Answer: Please make sure the transmitter resolution is in the technical specification. If not
please revise the resolution to the proper setting.
* Failure 5: Why is the TV showing “no signal” ?
Answer: Please check your HDMI connections. Make sure the TV input is in the correct HDMI
port, the TV is turned on and put to the right source (e.g. HDMI1) Is the source playing
movie? If not, please start the player.
* Failure 6: The TV has an image, but no sound?
Answer: Please check if the player and TV are not in a "mute" status. If the status is OK,
please unplug the HDMI cables, turn everything off, connect everything again and turn on
the TV and set it to the right channel and turn up the volume of the TV.
* Failure 7: TV with sound, but no image.
Answer：Please check the transmitter and receiver. if the connection is OK. please unplug
the kit and power it on again.
* Failure 8: When trying to watch a Blu-ray disk, some TV’s can't properly play the
image, but on some TV’s the image is OK?
Answer: the Blu-ray player need to meet the HDCP specifications, please make sure your
display support HDCP. If your TV does not support HDCP, there is no way to play a Blu-ray
disk on this display.
* Failure 9: The Transmitter and Receiver Network Link LED is blinking and the TV
has no image and sound?
Answer：Please unplug the power of the Transmitter and receiver and plug again. If the LED
keeps blinking, the device is defect, please contact your seller for repair.
* Failure 10: The TV has no smooth image?
Answer: Maybe the signal is not properly received. We suggest you to relocate the receiver.
Are the Transmitter and Receiver vertically positioned with the included brackets with the
Antenna Button in the upper position ?
* Failure 11: The remote control cannot operate properly?
Answer: Please check if the IR extension cable is properly plugged into the IR connector,
make sure the IR LED is aimed to the players control receiver area. Make sure the remote
control is a 38KHz IR control remote.