User guide

31-5-2012 5 ebode VLHD30
5. Hardware Overviews
Transmitter
① Receptor for the power Adapter
5V/2A, using power supply with different Voltage rating than the one included with the
VLHD30 will cause damage and void warranty for these products.
② HDMI Input Connector
Connect all devices with a good quality HDMI High Speed Cable to make sure
The connection is in the best possible condition.
③ IR signal output interface
Connect the IR extension cable and aim the IR head to the device which need to be
control. It will receive the IR signal from the Transmitter side and send it to the
Receiver side.
④ Network Link LED status
After the power is connected, the green LED in the front will show the communication
status. When the LED has turned green, your connection has succeeded. When the
green LED is off, the connection is not complete or out of range. When the LED is
flashing green, your device is defective.
⑤ Video Link LED status
When the HDMI cable is connected, the LED shows the video connected status. When
the LED is green, it show the video connect has succeeded. When the green LED is
off, it show the video connect has failed or is not complete, make sure your TV is on,
connected with the HDMI cable and on the right channel (source HDMI).
⑥ Frequency Reset button
When the received video image quality is poor, you can press this button for a short
time (less than 1 second). Then the transmitter is ready to change frequency and you
can start to change the transmitting frequency for every time you press this button.
⑦ Power LED.