User manual

31-7-2014 41 ebode IPV58P2P
③ Use domain name to access the camera via internet
After the port forwarding is finished, you can use the domain name+ http no. to access
the camera via internet. Take hostname ycxgwp.no-ip.info and http no 2000 for example,
the accessing link of the camera via internet would be http:// ycxgwp.no-ip.info:2000
6.3.5 UPnP
Figure 6.31
The default UPnP status is closed. You can enable UPnP, then the camera’s software will
be configured for port forwarding. Back to the “Device Status” panel, you can see the
UPnP status:
Figure 6.32
The camera’s software will be configured for port forwarding. There may be issues with
your routers security settings, and sometimes may error. We recommend you configure
port forwarding manually on your router (Figure 4.30).
6.3.6 Port
This camera supports HTTP Port / HTTPS Port/ ONVIF Port. HTTP Port is used to access
the camera remotely.
HTTP port : By default, the HTTP is set to 88. Also, they can be assigned with another
port number between 1 and 65535. But make sure they can not be conflict with other
existing ports like 25, 21.
Figure 6.33