Operation Manual

31-7-2014 27 ebode IPV38P2P
Click the Screen PTZ button and put the mouse on the screen to indicate the camera
move direction you prefer, press the left mouse, the camera will move to the
corresponding direction. Loosen the mouse and stop moving. Press Esc button or double
click right mouse and cancel the function.
NOTE: For Mac OS, the plugin cannot support Onscreen Mouse Control, so you cannot
allow to use it.
6 Advanced Camera Settings
Click the button “Settings”, goes to Administrator Control Panel to make advanced
camera settings.
6.1 Status
Status contains four columns: Device Information, Device Status, Session Status and
Log, it will show you various information about your camera.
6.1.1 Device Information
Figure 6.1
Camera Model: The camera model no.
Camera Name: The Device Name is a unique name that you can give to your device to
help you identify it. Click Basic Settings and go to Camera name panel where you can
change your camera name. The default device name is anonymous.
Camera ID: Display the wired MAC address of your camera. For example Device ID is
000C5D00008, the same MAC ID sticker is found at the bottom of the camera.
Camera Time: The system time of the device. Click Basic Settings and go to Camera time
panel and adjust the time.
System Firmware version: Display the System Firmware version of your camera.
App Firmware version: Display the application firmware version of your camera.
Web version: Display the web UI version of your camera
Plug-in version: Display the plug-in version of your camera
6.1.2 Device Status
On this page you can see device status such as Alarm status/ Record Status ,DDNS
status ,WIFI status and so on.