Operation Manual

31-7-2014 39 ebode IPV38P2P
Step 2: Click the SSID (name of your router) in the list, the corresponding information
related to your network, such as the name and the encryption, will be filled into the
relevant fields automatically. You will only need to fill in the password of your network.
Make sure that the SSID, Encryption and the password you filled in are exactly the same
for your router.
Figure 6.23
Step 3: Please click on the Save button after all settings have been entered and
disconnect the network cable. Never shut down the power of the camera until the IP
camera is able to connect to the wireless network.
The LAN IP address will disappear on the window of IP Camera Tool when the camera is
configuring a wireless connection. Wait about 1 minute, the camera should obtain a
wireless connection and the LAN IP of the camera will show again on the IP Camera Tool
window. The IP address may have changed after the camera receives a wireless
connection and we recommend setting a static local IP address if this IP address changes
by right clicking the camera in IP Camera Tools, setting a static IP and pushing OK
(figure 6.36). Congratulations! You have set up the wireless connection of the camera
successfully.
NOTE: If you fail to make a wireless connection, please refer to your seller.
WPS (Wi-Fi Protected Set-up)
Step 1) Press and hold the WPS button for two seconds. (figure 3.2 shows the WPS
button)
Step 2) Press the WPS button on your router within 60 seconds. The WPS button is
usually on the back or side of your router. On some routers, you may need to log in to
the web interface and click on an on-screen button to activate the WPS feature. If you
are not sure where the WPS buttons is on your router, please refer to your router’s User
Manual.
The camera will automatically create a secure wireless connection to your router. If you
have plugged in the network cable, please plug it out. The IP Camera Tool will search the
camera’s LAN IP. Make sure the PC and the camera share the same subnet.
NOTE: The security mode of router cannot be WEP, or else the WPS settings may be
failed.
1 Click the SSID of your
router and the relevant
information will be filled
in the fields automatically
2 Enter the password
of your router