User guide

Receiver - Micro Appliance Modules Ref : RMML

July 2009 page 7 RMML

Do not connect more lights as the total permitted amount of wattage allows.

1. CAUTION: Shut off power to the circuit in the electrical panel.

2. With the aid of a screwdriver press on the top of the terminal board and

insert the cables (for the light xture see diagram 1, for the power socket see

diagram 2). Then verify the connections by pulling lightly on the wires.

3. Pull out the antenna as far as you can for better reception.

PROGRAMMING

The Micro Transmitter commands must be recognized in order to add the Micro

Receiver to a different installation from the original or to one with interference

from a nearby system.

1. Proceed to make a “Reset”. Press down and hold the button in the (PROG)

opening with a paper clip until the LED lights up GREEN, then release it. The LED

should ash YELLOW: the Micro Receiver now has no code.

2. With the paper clip, press down briey in the (PROG) opening. The LED will

ash GREEN and wait for a command from a Micro Transmitter or remote control

switch.

3. Press one of the buttons on the Micro Transmitter or the remote control switch:

the Micro Receiver LED will stop blinking, conrming it has received the command.

The programming is done!

REMARKS

The RMML Micro Receiver will remember as many Micro-Transmitters and remote

control switches as necessary.

VERIFICATION

Verify On/Off switch operation.

You must wait about a second between each On / Off command.

When changing the battery, the registered code will be retained by the Micro

Transmitter.

Troubleshooting - please check FAQ and technical support on