User guide

13-3-2014 12 ebode TAKE6 IR/RF
You can control the ebode / X10 Home Automation
Modules as follows:
1. Press the ebode / X10 home automation button .
2. Use the numerical keys to select the Unit Code of the
Module of your choice (1-digit codes do not have to
preceded by a ‘0’).
3. Press the button of the function you want to execute
(see overview below).
ebode / X10 Home Automation functions:
On: CHANNEL +
Off: CHANNEL -
Brighter: VOLUME +
Dim: VOLUME -
All lights on: Power
All units off: Mute
Changing the X10 House Code
The TAKE 6 Remote is set to House Code A by default. In
most cases you do not need to change this setting, unless
another X10 system in your area causes interference.
1. Press the SETUP button until the LED stays lit. Release the
SETUP button.
2. Press the numerical key(s) for the House Code selected
(1=A, 2=B, ...... 16=P).
3. Press the -/-- (13) button to confirm the House Code.
The LED will extinguish.
Note: The House Code selected must be the same as the
House Code used by your Transceiver Module.
4.9 ebode / X10 IR Link RF Receiver
The ebode IR Link RF Receiver (available separately,
model code RE10CE) gives you the possibility to control all
your audio and video equipment with the TAKE 6
anywhere in your home. The TAKE 6 transmits an RF signal
to the IR Link RF Receiver module, which then transforms
this signal into an IR signal, which is sent to your device.
Here are some examples of the uses of the IR Link:
• Operate the DVD and satellite receiver from the
bedroom, without having to lay any extra cables.
• Turn up the volume of the radio in the living room while
you are in the kitchen.
The RF signal travels through walls, ceilings and closet
doors. Simply connect the receiver to a wall socket within
sight of your equipment: it could not be easier. Ask your
dealer about the possibilities.
5. Troubleshooting
The remote doesn’t work or loses codes entered
• Confirm with your original remote that the equipment
works correctly.
• Make sure that you have pressed the corresponding
mode key of the equipment or device that you want to
control.
• If the listed code does not work, try the AUTOSEARCH
method or enter the next code of that brand.
• Check that the batteries have the correct polarity
position.
• The programming of the remote requires 2x AAA
Alkaline batteries (new).
• If the LED is lit permanently, in general it will be
necessary to replace the batteries.