User guide

13-3-2014 4 ebode TAKE6 IR/RF
Quick start guide
a) Put the batteries in
1. Open the cover on the back of the TAKE 6
2. Insert the 2x AAA Alkaline. Make sure the batteries are
NEW.
b) Program your TAKE 6
1. Turn on the equipment that you wish to control ( TV,
DVR, DVD, STB, AUX/ , AUDIO). Please note that with
the TAKE 6 you can either select to control an appliance
or , not a combination of these two.
2. The AUX key allows you to program and control any
equipment such as TV, DVR, DVD, CD, STB, .
3. Take the code book supplied with the TAKE 6 and find
the brand of the equipment you wish to control. E.g. if
you have a Thomson TV look for Thomson under the TV
section.
4. Press and hold on the key marked "S" (8) until the LED
(2) stays permanently on. This takes about 3 seconds.
Release the "S key".
5. Press and release the TV, DVR, DVD, STB, AUX, AUDIO,
mode key (4), in accordance with the appliance you
wish to control.
6. From the code book take the first number
corresponding to your equipment and enter the number
by pressing the 0-9 key pad (14). Each time you press a
key the LED (2) will flash.
7. If the number is correctly entered the LED will turn off. If
the number is incorrect then the red LED will flash fast. If
incorrect you will need to restart at 4.
Press the POWER key (1) . If your equipment switches off
you have found the right code. If it does not switch off,
you will need to restart from 4.
Sometimes there are several codes that have similar
features. If you find that your TAKE 6 does not work for
some functions, you may need to try another code.
1. Introduction
The TAKE 6 is designed to control up to 6 devices: TV, DVR,
DVD, STB, AUDIO or any other device under AUX mode
key (Please note that you can either select to control an
appliance or , not a combination of these two.).
The TAKE 6 contains a library of codes that are
preprogrammed into the remote control. This library
covers nearly all the audio video products on the market
today. The codes have to be programmed once before
use. This can be done in different ways:
a. Manual entry of one of the codes displayed under the
related brand and type of equipment in the attached
code book (see 4.1)
b. Automatic code search for some well-known brands
(4.2)
c. Automatic code search for all brands (4.3)
d. Manual search through all codes (4.4)