User guide

13-3-2014 9 ebode TAKE6 IR/RF
4.5 Learning codes
Your TAKE 6 Remote contains the codes for most TVs,
videos etc. in its code library. If a certain device is not in
this library, you can learn the codes for your existing
remote control. The library may also contain a code that
works for your device, but which misses a few function
buttons. You can then select to only learn those buttons
(maximum of 150 buttons).
Master clear
You can use the MASTER CLEAR method to clear the
learning memory. It is advised to execute a MASTER
CLEAR before you start learning any commands.
1. Keep the SETUP (8) pressed until the LED stays lit.
Release the SETUP (8) button.
2. Press the LEARN (20) button twice. The LED will flash
every time you press the button.
3. Press SETUP (8). The LED will extinguish after a few
seconds.
Notes:
• Execute a Master Clear before you start learning (see
the method above).
• Make sure both remote controls have full batteries
before you start learning codes.
• Make sure you do not move the remote controls when
pressing the buttons.
• You cannot learn any commands for the following
buttons: Learn, Setup, Guide, Source buttons TV, VCR,
CBL, etc, Home Control.
• Experiment by learning two or three buttons first (to test
compatibility), before you learn all the buttons of your
original remote control.
• When the memory is full, the LED will flash for 3 seconds.
You cannot learn any codes when the memory is full. You
can, however, erase a mode with codes you stored. You
can only erase a full mode.
• By keeping the buttons for the existing remote control
pressed for a shorter period, there will be more memory
space left for learning codes on the TAKE 6 remote
control. This also diminishes the chance that the remote
control learns the wrong codes.
• Experiment with the distance between the remote
controls if you have problems learning the codes.
• Some remote controls do not have the infrared LED in
the centre. Try experimenting by slightly moving the
remote controls (sideways or up/down). Tube lighting and
bright sunlight can affect the procedure.
• You can only learn the codes for one original remote
control per mode, e.g. the codes for your DVD remote
control under the DVD button. With some combi devices
(e.g. a TV with built-in DVD player) you first have to learn
the TV functions in TV mode and then the DVD functions
in DVD mode.
Learning the commands
1. Point your existing remote control at the TAKE 6 Remote
(front to front). Keep a distance of 2,5 cm between the
remote controls.
2. Press the SETUP (8) button until the LED stays lit. Release
the SETUP (8) button.
3. Press the Mode button (TV, AUDIO, SAT, etc.) for the
device you want to learn. The LED will flash once.
4. Press the LEARN (20) button. The LED will flash once.
5. Press the button on the TAKE 6 remote you want to
store the new command under. The LED will blink once.