User guide

16-10-2009 8 033000=15299
under the AUX key, enter ANY STB code found in the code book and then
follow the steps below:
1. Make sure your equipment is switched on.
2. Press and hold S (8) until the LED indicator lights steadily. Release S
3. Press the mode key (4) that matches the equipment you want to control (for
example TV).
4. Press CHAN+ (6) repeatedly until the channel changes. If you step past the
correct code use CHAN- (6) to go back to the right code.
5. When the equipment you want to control reacts, press -/-- (13) to confirm
the code.
Note: If your equipment doesn't have CHAN+ you can use PLAY (DVR or DVD)
(15) or POWER (1) key. The search starts after the last registered code. If that
was 030, the search starts at 031 until the last possible code and then goes
from 000 to 029. Note: if certain functions of your equipment can’t be
controlled you will have to find a different code for your brand.
4.5 Identifying codes found
If you don’t know the code (for example because you found the code by
autosearch) you can identify it as described below:
1. Press and hold S (8) until the LED indicator (2) lights steadily. Release S.
2. Press the mode key (4) for the equipment you want to identify (DVR, DVD,
CD, STB, AUDIO or AUX). The LED blinks once.
3. Press again S. The LED blinks once.
4. To identify the first digit press each number button from 0 - 9 (14) until the
LED blinks. The number you pressed is the first digit of the code.
5. Press each number key from 0 - 9 as above to find the second digit.
6. Press each number key from 0 - 9 as above to find the third digit.
7. Press each number key from 0 - 9 as above to find the fourth digit. When the
fourth digit has been found the LED will go off.
4.6 Volume Control Punch Through
The TAKE 6 remote control allows you to select which Mode controls your
volume/mute buttons. The volume buttons VOL+ (5), VOL- (5) and Mute (3)
can be set for individual control by EACH device Mode or can be set for ALL
device Modes to punch-through volume control to one specific single device
Mode. The remote is initially set (Factory Default) for control by each specific
device Mode.
Adjustment of ALL volume controls to one mode.
You can allocate volume control to one of the modes of the remote control
providing that volume control exists on the corresponding device (e.g. control
of TV sound in DVR, DVD, etc... mode).
- Hold down the S (8) key until the LED remains lit.
- Release the S (8) key.
- Press and hold the MUTE (3) key until the LED flashes once, then release the
MUTE key.
- Press the required mode key, e.g. TV, corresponding to the device that will
control the VOL and MUTE buttons for ALL the device Modes.
- Press and release the MUTE (3) key and the LED turns off.
Adjustment of the volume controls for EACH mode.
You can allocate volume control to be individual for each mode selected,
providing that volume control exists on the corresponding device (e.g. control
of the television set sound in TV mode, the control of the sound of the STB
receiver in STB mode, ...).
- Hold down the S (8) key until the LED remains lit.
- Release the
S (8) key.
- Press and hold the MUTE (3) key until the LED flashes once, then release the
MUTE key.
- Press the required mode key, e.g. DVD, corresponding to the device that will
control its own VOL and MUTE keys.
- Press and release the VOL - (5) key once.
- Press and release the MUTE (3) key once and the LED turns off.