Operation Manual

30-1-2015 13 ebode VLHD38

No sound

or bad

sound

1. Make sure the source equipment output support audio format.

2. Restart the transmitter and connect it again.

3. Make sure there is no disturbance from the same frequency

(4.9～5.9GHz) within 50cm (Wi-Fi modem, microwave etc.)

failure

1.Ensure the distance between transmitter and receiver doesn’t

exceed supported distance. If it does, make them closer and try

it again.

2.Check if source device has been added on display equipment.

If it has, delete it and make registration again.

Connectio

n failure

1 Ensure the working distance doesn’t exceed supported distance.

If it does, make them closer and try it again.

2 Make sure source devices have been registered every time after

software update.

3 Ensure source devices and display devices have been registered.

4 If failure occurs again, delete all registered information and try

again.

5 When using the USB Power cables, make sure that the USB port

delivers sufficient Power. A minimum of 5V 1.5 Amp is required

to power the VLHD38. Please refer to the USB output device

manual to find out how much power the USB port can deliver.

Please also note that if a port delivers 1.5 Amp, and the USB port

is shared (example 3 ports), the output can be lower than 1.5

Amp when a second and/or third USB device is connected. We

recommend to test with the included Power adapters first. After a

successful connection, switch to USB Power cables (Receiver side

first) and retry.

Other

problems

If any other problems occur, please un-power all connected

devices and check again.

In case of any other problems, please read the frequently asked questions in part 5 first.

If this cannot help you to solve the problem, please visit our website and go to the FAQ

section. If there are any product firmware updates available they can be found on our

website www.ebodeelectronics.eu.

5. Sample of use