EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE USERS MANUAL www.ebssweden.
USERS MANUAL EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE THANK YOU FOR PURCHASING THE EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE PEDAL Thank you for purchasing the Billy Sheehan Ultimate Signature Drive! The ’Ultimate’ version has inherited all the features from the Deluxe version (including the possibility to swap the drive chip without the need of soldering). But the palette of sounds you can create is expanded by the new Hi or Lo frequency filter that gives the Tone control a much wider range.
EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE THE CONTROLS DRIVE USERS MANUAL DRIVE sets the gain for the classic overdrive engine, all from subtle to high gain tone. TONE fine tunes the desired frequency scoop, ranging from lower to higher midrange. TONE LEVEL sets the level for the drive channel. Post Drive Loop and before the compressor. LEVEL CLEAN CLEAN set the level for the clean channel. Post Clean Loop and before the compressor.
USERS MANUAL EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE BOOST FOOT SWITCH boosts the Drive gain level when activated. ACTIVE FOOT SWITCH Switches the pedal on or off. ADVANCED CONTROL OPTIONS (as illustrated on next page) REPLACEABLE OP-AMP CHIP - The chip can be removed and replaced without need of soldering. Try a different 8-pin op-amp for a different drive character. See EBS website for recommendations. BOOST (trimmer) - Sets the level of the boost footswitch from +3 to +10 dB THR.
EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE COMP LEVEL TRIM POT FOR MID POSITION (COMP) THRESHOLD LEVEL TRIM POT (THR) BOOST TRIM POT USERS MANUAL REPLACEABLE OP-AMP CHIP BATTERY SOCKET www.ebssweden.
USERS MANUAL EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE USING THE LOOPS The Billy Sheehan Ultimate Signature Drive pedal gives you the option to use additional effects to affect either the Clean or Drive channel independently (the photo shows a reverb connected to the Drive Loop). When using the loops, use an insert cable of a standard TRS type, such as the EBS ICY-30, where the RING is the SEND signal, and the TIP is the RETURN signal back to the pedal.
EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE USERS MANUAL BLOCK DIAGRAM www.ebssweden.
USERS MANUAL EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE TECHNICAL SPECIFICATIONS Nominal Input Level - 8 dBv Input Impedance 700 kohms Gain Range* Drive 20 - 50 dB Boost adjustable +3- 10 dB Tone Filter Range 175 - 8000 Hz in two ranges Q 0.7-0.
