User's Manual

Copyright ©2012–2020，Chengdu Ebyte Electronic Technology Co.,Ltd
17
5.4.17 AT+IPWR revise ibeacn tx_power
Command
Response
Inquiry
AT+IPWR?
+OK=[para]
Set
AT+ IPWR =[para]
+OK：success
+ERR=[NUM]：error
Parameter
para(HEX)： 0-0XFF
default：0
Note
1. Take effect immediately (if the broadcast is not turned on, or it is connected, it will take effect next time),
save when power off;
2. Only the slave device supports broadcasting, other roles can still be configured;
5.4.18 AT+NAME advertising device name
Command
Response
Inquiry
AT+NAME?
+OK=[para]
Set
AT+NAME=[para]
+OK：success
+ERR=[NUM]：error
Set
（Do not save）
AT+NAME1=[para]
Parameter
para(HEX): advertising device name,
advertising name is not more than 22 bytes
default：E104-BT52-V1.0
Note
1. Take effect immediately, save when power off;
2. Only supported by the slave, other roles can still be configured;
5.4.19 AT+ CONINTV connection interval configuration
Command
Response
Inquiry
AT+CONINTV?
+OK=[ para]
Set
AT+CONINTV =[para]
+OK：success
+ERR=[NUM]：error
Parameter
[para]（ASCII) : connection interval，value range，10~2500；
Default：20ms
Note
Take effect immediately, save when power off.
Note
1. The connection timeout must be greater than the connection gap;
2. The device with incorrect parameters will not receive and save.
3. It is not recommended to modify the host connection gap.
For example,
AT+CONINTV=20
Connection interval 20ms