User's Manual

Chengdu Ebyte Electronic Technology Co.,Ltd E07-900M10S User
Manual
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
7
1
GND
Ground wire, connected to the power reference ground
2
GND
Ground wire, connected to the power reference ground
3
GND
Ground wire, connected to the power reference ground
4
GND
Ground wire, connected to the power reference ground
5
GND
Ground wire, connected to the power reference ground
6
NC
No need to connect
7
NC
No need to connect
8
NC
No need to connect
9
VCC
Power supply, 3.0~3.6V (It is also recommended to add external
ceramic filter capacitor)
10
NC
No need to connect
11
GND
Ground wire, connected to the power reference ground
12
GND
Ground wire, connected to the power reference ground
13
NC
No need to connect
14
GD02
CC1101 chip pins (see CC1101 official user manual for details)
15
GD00
CC1101 chip pins (see CC1101 official user manual for details)
16
MISO/GD01
Output
SPI master output slave input
17
MOSI
Input
SPI master input slave output
18
SCK
Input
Serial Clock Input
19
CSN
Input
SPI Chip select for starting SPI communication
20
GND
Ground wire, connected to the power reference ground
21
ANT
Input/Output
Antenna, stamp hole（50 ohm impedance）
22
GND
Ground wire, connected to the power reference ground
4 Basic operation
4.1 Hardware design
 It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible and
the module needs to be reliably grounded;
 Please pay attention to the correct connection of the positive and negative poles of the power supply,
reverse connection may cause permanent damage to the module;
 Please check the power supply to ensure that between the recommended supply voltage, if exceeding the maximum,
the module will be permanently damaged;
 Please check the stability of the power supply. Voltage can not fluctuate greatly and frequently;
 When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of the
margin, so the whole machine is beneficial for long-term stable operation;
 The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other