Users Manual
Table Of Contents
- FCC Statement
- 1.Overview
- 2.Technical parameter
- 3. Mechanical characteristics
- 4. Operation mode
- 5.Transmission mode
- 6.Application function and instruction configurati
- 6.1 Function pin
- 6.2 Wireless remote configuration function
- 6.3 Touch link Functional application
- 6.4 Functional parameter description
- 6.5 HEX User instruction set
- 6.6 HEX Parameter description
- 6.6.1 System transmitting mode
- 6.6.2 Receiving data output mode
- 6.6.3 Network node type
- 6.6.4 Network state
- 6.6.5 Network PAN_ID
- 6.6.6 Network short address：
- 6.6.7 MAC address
- 6.6.8 Short address of father nodes
- 6.6.9 MAC address of father nodes
- 6.6.10 Network group number group
- 6.6.11 Network Channel
- 6.6.12 Transmitting Power
- 6.6.13 Buad rate
- 6.6.14 Sleep time
- 6.6.15 Storage time of father nodes
- 6.6.16 Centralized network opening time
- 6.6.17 Period of network reconnection after loss o
- 6.6.18 The maximum number of attempts to reconnect
- 6.6.19 Wireless remote configuration ID
- 6.6.20 User gpio parameter
- 6.6.21 User pwm parameter
- 6.6.22 User adc parameter
- 6.6.23 Configure all network parameters
- 6.6.24 Configure all network parameters
- 6.6.25 Number of end-devices of the parent node
- 6.6.26 Parent node's end-device list
- 6.6.27 Configure the delayed printing time of AUX
- 6.6.29 Configure endpoint information
- 6.6.30 Set Link key of trust center
- 6.6.31 firmware version number
- 7.Quick start
- 8. Secondary development design reference
- 9.FAQ
- Revision history
- About us
Chengdu Ebyte Electronic Technology Co.,Ltd. E180-ZG120B User Manual
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co.,Ltd.
9
3. Mechanical characteristics
Pin No.
Pin item
Pin
direction
Application
1
ANT
Input /Output
Externally connected with stamp hole
2
GND
Ground, connecting to power source referential ground
3
PD13
Input
TOUCHLINK pin to be continuously pulled lower than 3000ms and it will
initiate a ZLL network or join request
4
PD14
Input
The WAKE pin is mainly used to wake up the sleeping terminal. It is high level
when power is on. When the pin is pulled low externally, the sleeping terminal
device will be woken up.
5
PA0(TX)
Output
UART TX pin
6
PA1(RX)
Input
UART RX pin
7
PA2
Input /Output
Reserve
8
PA4
Input /Output
Reserve
9
PB11
Input
Working mode switching pin. When the pull-down time is longer than 500ms,
the working mode is switched.
10
PB12
Input
The UART_BAUD_RESET pin is used to reset the device baud rate. The
power-on default is high. In any mode, if this pin is pulled lower for more than