Users Manual
Table Of Contents
- FCC Statement
- 1.Overview
- 2.Technical parameter
- 3. Mechanical characteristics
- 4. Operation mode
- 5.Transmission mode
- 6.Application function and instruction configurati
- 6.1 Function pin
- 6.2 Wireless remote configuration function
- 6.3 Touch link Functional application
- 6.4 Functional parameter description
- 6.5 HEX User instruction set
- 6.6 HEX Parameter description
- 6.6.1 System transmitting mode
- 6.6.2 Receiving data output mode
- 6.6.3 Network node type
- 6.6.4 Network state
- 6.6.5 Network PAN_ID
- 6.6.6 Network short address：
- 6.6.7 MAC address
- 6.6.8 Short address of father nodes
- 6.6.9 MAC address of father nodes
- 6.6.10 Network group number group
- 6.6.11 Network Channel
- 6.6.12 Transmitting Power
- 6.6.13 Buad rate
- 6.6.14 Sleep time
- 6.6.15 Storage time of father nodes
- 6.6.16 Centralized network opening time
- 6.6.17 Period of network reconnection after loss o
- 6.6.18 The maximum number of attempts to reconnect
- 6.6.19 Wireless remote configuration ID
- 6.6.20 User gpio parameter
- 6.6.21 User pwm parameter
- 6.6.22 User adc parameter
- 6.6.23 Configure all network parameters
- 6.6.24 Configure all network parameters
- 6.6.25 Number of end-devices of the parent node
- 6.6.26 Parent node's end-device list
- 6.6.27 Configure the delayed printing time of AUX
- 6.6.29 Configure endpoint information
- 6.6.30 Set Link key of trust center
- 6.6.31 firmware version number
- 7.Quick start
- 8. Secondary development design reference
- 9.FAQ
- Revision history
- About us
Chengdu Ebyte Electronic Technology Co.,Ltd. E180-ZG120B User Manual
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co.,Ltd.
11
4.2 Configuration mode
When the module enters the configuration mode, the data received by the serial port defaults to the configuration
instruction, which configures and operates the function of the device. In the configuration mode, the data received by the
serial port is regarded as the hex instruction.
4.3 Mode switch
4.3.1 Command switch
The module power on initialization defaults to the transmission mode
In transmission mode, when the serial port receives "2A 2D 2E" character, it will enter the configuration mode. After
entering the configuration mode successfully, it will return "7A 7D 7E " character. In configuration mode, when the
serial port of the module receives "2F 2C 2B " character, the module exits the configuration mode, enters the
transmission mode, and returns "7F 7C 7B" character after entering the transmission mode successfully.
4.3.2 Pin switching
Working mode switch pin PB11, internal configuration pull-up resistance input mode, power on default high level,
in any mode, when mode switch pin PB11 is pulled down more than 500ms, the module working mode switch, as shown
in the figure below:
5.Transmission mode
5.1 Data transmission mode
The data transmission mode includes unicast, broadcast and multicast.
5.1.1 Broadcast mode
In broadcast mode, the sending device sends the data received by the serial port to each node in network (including
itself), and all non-sleeping devices in network will receive data.
pin level
Pin level pulse
>500ms
Pin level pulse
Configure
Tansmit