User's Manual

Chengdu Ebyte Electronic Technology Co,;Ltd E70-915T30S user manual

Transmitting

Wireless data transmission is not available

Receiving

Wireless data receiving is not available

Baud rate & air

data rate

Current baud rate

Advantage

RSSI value of one byte output every 100ms can indicate the noise value of current environment.

Disadvantage

Data transmission and receiving are not available

Applications

For monitoring environmental noise

Note

6.3 Continuous Mode (Mode 1)

Status

M0=1 M1=0 M2=0

Transmitting

Wireless data transmission is available.

Receiving

Wireless data receiving is available.

Baud rate & air

data rate

Module will calculate the minimum air data rate according to the configured baud rate. Since the modules with different

air data rate cannot communicate, the serial port parameters must be the same on both receiver and transmitter.

Advantage

The data output on the receiver is continuous, it meets the requirements for MODBUS continuous transmission and low

latency.

Disadvantage

The baud rates on both receiver and transmitter must be same. The module will raise its air data when the baud rate is

raised, thus the receiving sensitivity will be lowered and operation range will be shorter.

Applications

Applicable for those applications not requiring distance but continuous data and response time.

Note

1. The “wireless air data rate” in the configuration commands is invalid (SPED.210 bits) and software will calculate

automatically.

2. 0000 and FFFF are the broadcast addresses, which can be used to monitor and broadcast.

3. The addresses and baud rates must be same on both receiver and transmitter.

4. In continuous mode, both transmitter and receiver must be same model. For example, E70 (868T14S) and E70

(868T30S) cannot communicate in continuous mode.

6.4 Sub-package Mode (Mode 2)

Status

M0=0 M1=1 M2=0