Installation Guide

9
ENGLISH
Support: Support.Eccotemp.com Shop Online: Eccotemp.com Store Locator: Eccotemp.com/locator
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY. BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
AND ALL AIR IS REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
INSTALLATION
Installation Instructions
CHOOSE A LOCATION
Select a location that allows ease of access for maintenance, ideally with at
least 9 inches of clearance at the top from any ceiling or cabinet interior.
Note: Only install in a vertical position.
A licensed professional should complete the installation adhering to all state
and local codes. The manufacturer will not be liable for any damages because
of failure to comply with these installation instructions or because of improper
installation performed by an qualied installer.
Wall Mounted
Fasten the supplied mounting bracket
to the wall. Use screws that are
suitable for the wall material and the
weight of the water heater lled to
capacity (ESH-2.5-41 lbs.; ESH-4.0-
57 lbs.). Hang the water heater on
the bracket and pull downwards on
the water heater to ensure that both
ngers of the bracket are seated in
the mounting slots.
Note: Conrm your water piping
orientation (hot and cold) before
wall mounting.
Free Standing
Sit on the oor under a sink or in a
cabinet, upright, as pictured in the
diagram below and on the front cover
of this manual.
Note: Make sure to leave at least nine
(9) inches of clearance above your
water heater.
THE FUTURE OF EFFICIENCY
Wall MountedFree Standing on Floor
Wall
Anchor
Temperature
Control
Do Not Block
ESH 2.5 = 10.9 Inch
ESH 4.0 = 12.5 Inch