Installation Guide

Support: Support.Eccotemp.com Shop Online: www.Eccotemp.com Store Locator: Eccotemp.com/locator
EnglishEnglish
39
PLEASE NOTE: SH22 IS FOR OUTDOOR PERMANENT INSTALLATIONS ONLY AND SH22I IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL
AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Designed in
S
umme
rv
ille, SC
Support: Support.Eccotemp.com Shop Online: www.Eccotemp.com Phone: [phone]
WARNING: If you do not follow these instructions exactly, a re or
explosion may result causing property damage, personal injury or loss of life.
FOR YOUR SAFETY BEFORE USING THE WATER HEATER
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO WATER HEATER
A. This water heater does not have a pilot. It is equipped with an ignition device which automatically
lights the burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the water heater area for gas. Be sure to smell next to the
oor because some gas is heavier than air and will settle on the oor. Test all connections with
a commercial leak detector or soapy water.
WHAT TO DO IF YOU SMELL GAS
• DO NOT try to light any appliance • DO NOT touch any electric switch; DO NOT use any
phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions. • If you cannot reach your gas supplier or re department. • DO
NOT return to your home until authorized by the gas supplier or re department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it, call a qualied service technician. Force or
attempted repair may result in a re or explosion.
D. DO NOT use this water heater if any part has been under water. Immediately call a qualied
service technician to inspect the water heater and to replace any part of the control system and any
gas control which has been under water.
1. STOP! Read the safety information above on this label.
2. Turn o all electric power to the water heater.
3. Set the thermostat to lowest setting.
4. DO NOT attempt to light the burner by hand.
5. Turn the Gas shut o Valve located on the outside of the
unit clockwise to the “OFF” position.
6. Wait ve (5) minutes to clear out any gas. If you smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t smell gas, go to the next step.
7. Turn the gas shut o valve located on outside of the unit counterclockwise to the “ON” position.
8. Turn on all electric power to the water heater.
9. Set thermostat to desired setting.
10. If the water heater will not operate, follow the instructions “To Turn O Gas To Water
Heater” and call your service technician or gas supplier.
1. Turn o all electric power to the water heater if service is to be performed.
2. Turn the gas shut o valve located on the outside of the unit clockwise to the “OFF” position.
WARNING: If you do not follow these instructions exactly, a re or
explosion may result causing property damage, personal injury or loss of life.