Owner´s Manual CURING LIGHT EC 500
Av. 2 POT NÚM TEN ÊNC ERO SÃOMOD IA: DE ECE ELO Mog 10 : MUL SÉR L VA : iana Indú IE - TIVOEC Bras , FRE stria / SER LTA500 il 1854 - CEP e IALQ. GEM - Ribe Com 50/6 : 1407 NUM irãoércio 0Hz BER 5-26 Pret Ltda : 0 o . - SP E 000 000 Av. NÚPO METÊ TEN RONC SÃ MO IA: O: DE DE ECE Mog 10 MU LO SÉR L VA LTI : EC iana Ind IE Bra úst FRVO 500 / SER sil, 185 ria EQLTA - CEP 4 e IAL . GE - Rib Com M : 140eirã NU50/60H érc MB 75-2o io ER: z Pre Ltd 60 to a. - SP E 000 000 8 Fig. B Fig.
CONGRATULATIONS! You have just purchased an equipment which uses the latest technology available in the market, designed to provide maximum result, quality and safety. ! For greater safety, read and understand all the instructions contained in this manual before installing or operating this equipment. All the information, illustrations and specifications included in this manual are based on data available at the time of its publication.
Product Presentation Packaging (single): Box (dimensions: 235mm x 190mm x 90mm) List of items contained in the box: 01 Handpiece, 01 Charger Base, 01 Acrylic curing light tip, 01 Eye protector, 01 Battery, 01 Charger and 01 Owner's manual.
halogen lamp (with estimated useful life of around 50 hours). It offers an estimated useful life of around 10.000 hours, avoiding the frequent replaces of lamp. Another important feature is the cold light, which generates a minimum of heating to the resin and the tooth. It eliminates the use of filters, because the light is emitted in the appropriate spectrum (approximately 470nm). The light is directional, and emitted by a tip attached to the handpiece front.
Discharged battery: the equipment emits two tones consecutives every 10 seconds of operation of the Led. Exhausted battery: the equipment emits three tones consecutives and turns the Led off, preventing the operation. Perform the procedure to recharge the battery if the equipment indicates Discharged battery or Exhausted battery. Cleaning and Care Clean the equipment surface with a clean soft cloth moistened with neutral detergent. The light guide tip must be cleaned with gauze or soft cloth.
In order to prevent electric shock, do not insert any object into the equipment. It will not be allowed to modify the product, under any condition. Any disassembly or modification causes the invalidity of the product guarantee. Do not use the equipment on patients with cardiac pacemakers. Battery Disposal Dispose the battery at an appropriate site (according to local regulations), avoiding environmental contamination and its inadequate use.
After Installation . Keep the product protected from direct sunlight and rain.
Transportation and Storage Conditions The product must be transported and stored: - Carefully in order to prevent vibrations and impacts. - By keeping the side indicated by the arrow facing upwards. - By observing maximum piling limits indicated on the packaging. - Protected against humidity, rain and direct sun.
Final Recommendations In order to ensure greater durability for your equipment, use only original replacement parts, which are in accordance with the technical standards and specifications required by the manufacturer. In addition, use only the services provided by the Authorized Technical Assistance Network as it counts on trained assistants and specific tools for the appropriate maintenance of your equipment.
Troubleshooting 11 Fault Equipment does not start Cause Battery Low Solution Charge the battery Cause Inadequate contact with the battery Solution Clean the circuit board, the battery connector and the handpiece. Connect the handpiece to the battery again.
ECEL - ABRIL/2009 Ecel Indústria e Comércio Ltda. Fone: (55) 16 3878-1700 - ecel@ecel.ind.br - www.ecel.ind.br Av. Mogiana, 1854 - Jd.
