User Manual
English
17
• Insert the valve by pushing it back into the recess.
• Use a thin object to remove any dirt around the valve.
• Insert the pressure valve by pushing it back into the recess.
• Push until it clicks into place.
Cleaning the oating pressure indicator
• Clean the oating pressure indicator with a thin object to make sure there is no dirt in or around it.
• Check that the valve can be lifted and that it falls back down without getting stuck.
Removing the inside of the lid
• Grasp the rubber knob in the center of the inside of the lid and pull it out.
• Clean the inside of the lid in warm soapy water.
• Clean the lid with warm soapy water as well. Do not use aggressive cleaners.
Seal removal
• Pull the rubber seal from the sides of the inside of the lid.
• Wash the seal with warm sapy water.
• Replace the seal around the edge of the inner lid.
• Slide the rubber knob back into place on the inside of the lid.
• Put the inside of the lid back on the pin in the middle of the lid.
• Cleaning the pressure cooker body: Never immerse the body of the pot in water or other liquids.
• Wipe the outer surface with a damp cloth and dry thoroughly with a soft dry cloth. Do not use aggressive
cleaners.
Condensation container
• There is a condensation container on the back of the pressure cooker.
• Pull the condensation container out of the mounting under the hinge.
• Wash the container with warm soapy water and then dry it with a soft cloth.
• Slide the condensation container back onto the underside of the hinge.
Additional notes on cleaning
• Make sure that the oating pressure indicator on the lid of the pressure cooker is not clogged and can
move freely up and down, wipe it if necessary.