Instruction manual

38
EN
Battery operation
Open the battery compartment and insert 6 batteries size LR14 (UM-2). Observe the correct polarity of the
batteries, otherwise the device will not function.
Important: If you will power the device exclusively from the wall outlet or if you do not plan to use the device
for more than a month, remove the batteries to prevent damage to the device caused by battery
leakage.
BOTTOM VIEW
1
2
4
3
5
6
6 x UM-2 / LR14 (1,5 V)
LISTENING TO THE RADIO
Set the functions switch to the desired bandwidth (AM or FM).
Tune the desired station by turning the tuner.
Adjust the telescopic antenna (FM) or the location of the device (AM) to achieve optimal reception.
Set the volume control to the desired level.
If you want to switch o the radio, move the function switch to “OFF”.
HEADPHONES JACK
This device is equipped with 3,5 mm headphones jack, suitable for most standard headphones (not included).
When you connect the headphones to the device, the built-in speakers will be automatically disconnected.
When you unplug the headphones, the speakers start functioning again.
INSERTING AND REMOVING A DISC
• Make sure prior to opening the battery compartment that the disc stopped (does not turn). Always stop
the disc by pressing STOP before opening the disc tray.
• Place the CD on the disc tray with the label facing up. Push on the centre of the disc so that it “clicks” on
the spindle.
• After placing the disc on the disc tray, gently close the door downwards in such a way that it locks closed.
• CD is now ready to be played.
• When removing the disc, proceed in similar way. Put one  nger at the centre of the disc (axis), the thumb
at the edge of the disc and remove it gently upward.
• IMPORTANT: When handling the discs, hold them always by the edges in order that you do not leave
 ngerprints on their surface and do not smudge them. If that happens, clean the disc using special
cleaning cloth or cleaning set.
PLAYING CD
1. Insert the disc as described above.
2. Move the functions switch to “CD/MP3/USB/AUX” (CDR 699 USB) / “CD/AUX” (CDR 699) position.
3. The CD turns brie y and the display shows the total number of tracks on the disc.
4. You can stop playing the disc any time during playing by pressing the PLAY/PAUSE button. Press again
PLAY/PAUSE to restart playing from the place where you interrupted the playback.
5. You can stop playing any time during playback by pressing the STOP button. When you start playing
again, the disc starts playing at track 1.
6. You can skip during the playback one track ahead or one track back by pressing the BACK/NEXT buttons.