User guide

Use the Mini EVK Application to load other example applications and
to create your own applications.
1. Click the Windows Start button, point to All Programs, point to Echelon
Mini EVK
, and then click Mini EVK Application.
2. To create an application, write Neuron C code using a text editor of your choice
such as Windows Notepad, and then use the
Application tab to select your
source file, select your target hardware, and then build an application image.
Alternatively, you can select one of the example applications.
3. Click the
Device tab, select LON1 as the network interface, and then click
Connect.
4. Press the
Service button on your device, and then click OK to select the device.
5. Select an application image to load, and then click
Load to load the application
image into the device.
For more information, see the following documentation included in your
Echelon Mini EVK pr
ogr
am folder:
Mini EVK User’s Guide—for more information on the examples and how to
develop applications with the Mini
Application.
Mini EVK Hardware Guide—for more information on the Evaluation Boards
and MiniGizmo.
Introduction to the LONWORKS
®
System—for more information on the
L
ONWORKS platform.
Run the Monitoring & Control Example Application.
1. Click the Windows Start button, point to All Programs, point to Echelon
Mini EVK
, and then click Monitoring & Control Example Application.
2. Select
LON1 as the network interface, and then click Connect.
3. Click
Add to open the Add Device dialog, and then press the FT 3150 Evaluation
Board’s
Service button. The board’s Neuron
®
ID appears on the Add Device dialog.
4. Click
OK to connect the board to the Monitoring & Control Example Application.
5. Control the MiniGizmo LEDs by clicking the light switch icons, and monitor the
MiniGizmo temperature sensor.
Copyright © 2005, Echelon Corporation. Echelon, LONWORKS, Neuron, 3120, 3150, and the Echelon logo are registered trademarks of Echelon Corporation. Other marks belong to their respective holders. P/N 078-0313-01B
5
6
4