User`s guide

PCLTA-20 PCI Interface User's Guide 3-3
suggested by the error message, produces the diagnosis: “Image file not found.” In this
case, return to the control panel application’s main window and manually initialize the
PCLTA-20 card.
Device Specific Settings
The PCLTA-20-specific options consist of five separate controls (figure 3.2). These
controls are defined as follows:
Figure 3.2 PCLTA-20-specific Controls
Device Selected
Controls which PCLTA-20 card is selected for configuration. The PCCLON1 and
PCCLON2 drivers are installed by the installation software. If additional drivers have
been manually installed, they also will be available.
Automatic Flush Cancel
For non-LNS images, this function controls whether the device driver will
automatically force the network interface for the selected PCLTA-20 card to leave the
post-reset flush state whenever it is reset; an LNS network interface does not and
cannot come up in the flush state. The post-reset flush state prevents any inbound or
outbound network traffic following a reset. If this box is not checked, it is up to
the client application to manage this state. If it is checked, the device driver will
automatically allow network traffic to resume. The default is checked.
NI Application
Controls the type of image or application to be used on the PCLTA-20 card. This
selection is handled automatically by the protocol analyzer software. For all other
applications, a PCLTA-20 card can only hold one image at a time. Loading a new
image will replace the currently loaded image. The choices for these images are
determined by the image files (.NBI extension) found in the system image path
specified under General Settings. Some of the possibilities include the following:
• PCL10VNI, the LNS Fast Network Interface image (for use with LNS 3 and
newer)