User`s guide

3-4 Configuring and Testing the PCLTA-20 Card
• NSIPCLTA, the LNS network interface image (for use with LNS 1 and LNS 2
only)
• PCC10L7, the basic network interface application image
Transceiver
Opens the PCLTA-20 Transceiver dialog (figure 3.3). Choosing this option will retrieve
the transceiver configuration of the selected PCLTA-20 card. If there is no PCLTA-20
card currently installed in a PCI-bus slot, a message appears stating that the operating
system has removed, or has not loaded, the PCLTA-20 device driver.
Figure 3.3 PCLTA-20 Transceiver Dialog Box
The Transceiver value specifies the transceiver type for the selected PCLTA-20 card.
The default transceiver is a TP/FT-10 compatible transceiver. Other standard
transceiver configurations, and a custom configuration, may be chosen. The Custom
Properties values are not accessible unless the Custom transceiver type is selected: you
cannot modify the transceiver type as it is a product of the transceiver ID (XID),
however, if the XID is custom then you can modify the fields using the Custom
Properties dialog box. If an incorrect transceiver type error is received while modifying
the transceiver type, click the Apply button, then proceed to modify the transceiver
type.
The Custom Properties area contains custom transceiver properties. The information
in this area reflects the current configuration within the PCLTA-20 card. It will not
change until a transceiver is selected, and then configured using the OK or Apply
buttons.